Long term monitoring and evaluation of the excavation damaged zone induced around the wall of the shaft applying optical fiber sensor (Cooperative research)

Hata, Koji*; Niunoya, Sumio*; Uyama, Masao*; Nakaoka, Kenichi*; Fukaya, Masaaki*; Aoyagi, Kazuhei; Sakurai, Akitaka; Tanai, Kenji

JAEA-Research 2020-010, 142 Pages, 2020/11

JAEA-Research-2020-010.pdf:13.74MB
JAEA-Research-2020-010-appendix(DVD-ROM).zip:149.9MB

In the geological disposal study of high-level radioactive waste, it is suggested that the excavation damaged zone (EDZ) which is created around a tunnel by the excavation will be possible to be one of the critical path of radionuclides. Especially, the progress of cracks in and around the EDZ with time affects the safety assessment of geological disposal and it is important to understand the hydraulic change due to the progress of cracks in and around EDZ. In this collaborative research, monitoring tools made by Obayashi Corporation were installed at a total of 9 locations in the three boreholes near the depth of 370 m of East Shaft at the Horonobe Underground Research Laboratory constructed in the Neogene sedimentary rock. The monitoring tool consists of one set of "optical AE sensor" for measuring of the mechanical rock mass behavior and "optical pore water pressure sensor and optical temperature sensor" for measuring of groundwater behavior. This tool was made for the purpose of selecting and analyzing of AE signal waveforms due to rock fracture during and after excavation of the target deep shaft. As a result of analyzing various measurement data including AE signal waveforms, it is able to understand the information on short-term or long-term progress of cracks in and around EDZ during and after excavation in the deep shaft. In the future, it will be possible to carry out a study that contributes to the long-term stability evaluation of EDZ in sedimentary rocks in the deep part of the Horonobe Underground Research Laboratory by evaluation based on these analytical data.

The In-situ experiment for overpack corrosion at Horonobe Underground Research Laboratory; Production and setting simulated overpack, buffer material blocks and heater

Nakayama, Masashi

JAEA-Technology 2018-006, 43 Pages, 2018/08

JAEA-Technology-2018-006.pdf:5.32MB
JAEA-Technology-2018-006-appendix(CD-ROM).zip:29.19MB

The Horonobe URL Project has being pursued by JAEA to enhance the reliability of relevant disposal technologies through investigations of the deep geological environment within the host sedimentary formation at Horonobe, Hokkaido. The URL Project proceeds in 3 overlapping phases, "Phase I: Surface-based investigations", "Phase II: Investigations during tunnel excavation" and "Phase III: Investigations in the underground facilities", over a period of around 20 years. The OP corrosion test was prepared from 2013 FY at Niche No.3, and heating by electric heater in simulated overpack started in November, 2014. The objective of the test is acquiring data concerned with corrosion of carbon steel OP. These data will be used in order to confirm the performance of engineered barrier system. In the OP corrosion test, the diameter of simulated OP and buffer material are 100 mm and 300 mm, respectively. Concrete support using low alkaline cement was used in order to investigate the effect of cementitious materials to OP corrosion behavior. We will measure corrosion potential of carbon steel, natural potential, pH in buffer material for several years. In this report, we describe how to make simulated OP and buffer material blocks, and set sensors, and so on.

Design and verification of support system for underground excavations under anisotropic stress conditions

Motoshima, Takayuki*; Fujita, Tomoo; Aoyagi, Kazuhei; Shirase, Mitsuyasu*; Nago, Makito*

Proceedings of 7th International Symposium on In-situ Rock Stress (RS 2016) (Internet), 9 Pages, 2016/05

Horonobe Underground Research Laboratory Project; Investigation report for the 2013 fiscal year

Hanamuro, Takahiro

JAEA-Review 2014-039, 69 Pages, 2014/10

JAEA-Review-2014-039.pdf:43.66MB

The Horonobe Underground Research Laboratory Project is planned to extend over a period 20 years. The investigations will be conducted in three phases, namely "Phase 1: Surface-based investigations", "Phase 2: Construction Phase" (investigations during construction of the underground facilities) and "Phase 3: Operation phase" (research in the underground facilities). This report summarizes the results of the investigations for the 2013 fiscal year (2013/2014). The investigations, which are composed of "Geoscientific research" and "R&D on geological disposal technology", were carried out according to "Horonobe Underground Research Laboratory Project Investigation Program for the 2013 fiscal year". The results of these investigations, along with the results which were obtained in other departments of Japan Atomic Energy Agency (JAEA), are properly offered to the implementations and the safety regulations. For the sake of this, JAEA has proceeded with the project in collaboration with experts from domestic and overseas research organisations.

Current status of the in-situ experiment for verification of performance of engineered barrier system in Horonobe Underground Research Laboratory

Nakayama, Masashi; Ono, Hirokazu; Shirase, Mitsuyasu*; Niunoya, Sumio*

no journal, , 

Japan Atomic Energy Agency is conducting the in-situ experiment for verification of performance of engineered barrier system in Horonobe Underground Research Laboratory. The purpose of this paper is reporting the current status of the experiment. This paper also reports the results of saturation status of buffer material blocks.